If you go to take your driver's test chances are that, if your a car Enthusiast, this is one of the most exciting days of your life and even if you're not it opens up a world of possibilities for traveling and do things you never could have done before. If you follow these few simple tips you'll be well on your way and you'll pass it with flying colors.
Before leaving the parking lot and getting out on the road is important to adjust your mirrors, your seat position, steering wheel position and of course fasten your seatbelt.
Proper hand position is at 9 and 3, and i guarantee if you drive one-handed at the 12 position you're going to fail your test. It's important to keep both hands on the steering wheel at all times. Of course if you have a manual transmission vehicle you have to take one hand off the ship, but this will keep your test administrator feeling safe and you will be in the most control of your vehicle.
When changing lanes is important to do the following: First Signal, then look in your rearview mirror all by your side mirror, look over your shoulder, and if is safe, then you can go. Once you're in the lane that you're moving into all the way, then you can turn your turn indicator. Always signal if you're changing lanes no matter if there's no traffic around you, for the driver's test it is important to check both mirrors, look over your shoulder and use your turn signal.
If you're going over multiple Lanes always go from one lane to the next, pause for a little bit of time, then turn your turning indicator on, look at both mirrors over shoulder, go to the next line, pause and then go to the next. Shooting over across 4 Lanes of traffic is a good way to fail the test.
Always give yourself plenty of time when pulling out onto a street with a high speed limit. It will not annoy the person providing your test if you wait there until it's safe.
If you pull out in front of a car that is moving quickly and do not give yourself enough room you're going to lose points. Waiting until there's plenty of space, more so than you think you would need normally, it is the proper way to do it.
Often beginner drivers tend of fear to one side of the lane or the other. On a single Lane road that means you might been too close to the double yellow or too close to the shoulder. To prevent that there is a technique that some people used that is helpful when you're learning , is to look farther ahead in the road and try to imagine the center of the road, picture a line in the center of the lane you're in passing through the center of your vehicle. This helps keep you in the center of your lane which is important for succeeding at the driver's test.
When coming to a stop sign or an stop or red light is important to stop before the white line in the road. That mean, when you're coming to a full stop, you should still be able to see the white line in front of the hood of your car ( This is important ). Then, if it's a blind turn, once you come to a full start, now you can start creeping out a little bit further and further so you can see the flow of traffic and make your right or left turn. Always use a safe following distance between yourself and the car is in front of you. The higher the speed limit is, the more the following distance because, if the person in front of you breaks all the sudden, you want to give yourself enough time to react.
Also, before you break, always check your rearview mirror. If you come onto a stop abruptly and there's a car right behind you, they could run into you. Obviously if it's an emergency situation this isn't always possible, but in the ideal case always check your mirror before braking.
Always keep your eyes moving. that means constantly scanning the road for pedestrian, any obstacles or turns that are coming up that means checking your mirrors constantly ( Your rearview mirror, your side mirrors, looking over your shoulder, etc ). Being attentive and showing that you're paying attention is going to go a long way to pass your driver's test.
When making protective left turns people often cut corners. Is something that everyone does on the road all the time: passing over a double yellow or a white line is a great way to fail your driver's test so make sure to take it wide enough, stay in the guidelines when you're making left turns and not cut any corners.
Be as smooth as possible. this means smooth steering inputs, smooth braking and smooth acceleration. Being jerky is not going to go well.
Drive defensively not aggressively. This day is about proving that you are a safe driver.
Don't speed. This is very important. In general people are used to going 5 miles an hour over the speed limit or so when driving in a daily situation but for the test you cannot do that. Speed limit or below is required.
Also having a radar detector in your car for the test probably won't leave a very good first impression.
The DMV wants to make sure that you are proficient with all the controls on the inside the car before you start your test.
Here's a sample of the pre Drive checklist:
This website is privately owned and is not affiliated with any government agency. Remember that we are never going to solicit any personal information, ID or credentials. To find a list of official websites, please click here