Open on the 2nd and 4th Tuesday of each month. Closed from noon to 12:30 p.m. // Testing ends at 11:45 a.m. & 3:45 p.m. // Motorcycle testing: 10 a.m. (pavement must be drive).
| Tuesday | 9:00am - 4:00pm |
100 S. Main St. , Suite 003, 63461
(573) 769-3264
If you go to take your first driver's test chances are that, if your a car Enthusiast, this is one of the most exciting days of your life and even if you're not it opens up a world of possibilities for traveling and do things you never could have done before.
If you follow these few simple tips you'll be well on your way and you'll pass the test with no problem.
Before leaving the parking lot and getting out on the road is important to check out your mirrors, adjust your seat position, adjust the steering wheel position and of course fasten your seatbelt.
Proper hand position is at 9 and 3, and i guarantee if you drive one-handed at the 12 position you're going to fail your test. It's important to keep both hands on the steering wheel at all times. Of course if you have a manual transmission vehicle you have to take one hand off the ship, but this will keep your test administrator feeling safe and you will be in the most control of your vehicle.
When changing lanes is important to do the following: First Signal, then look in your rearview mirror all by your side mirror, look over your shoulder, and if is safe, then you can go. Once you're in the lane that you're moving into all the way, then you can turn your turn indicator. Always signal if you're changing lanes no matter if there's no traffic around you, for the driver's test it is important to check both mirrors, look over your shoulder and use your turn signal.
Now if you're going over multiple Lanes ( For example you're on a four-lane road ) always go from one lane to the next, pause for a little bit, then turn your turning indicator on, look at both mirrors over shoulder, go to the next line, pause and then go to the next. Shooting over across 4 Lanes of traffic is a good way to fail the test.
Always give yourself plenty of time when pulling out onto a street with a high speed limit. It will not annoy the person providing your test if you wait there until it's safe. If you pull out in front of a car that is moving quickly and do not give yourself enough room you're going to lose points. Waiting until there's plenty of space, more so than you think you would need normally, it is the safe way to do it.
Often beginner drivers tend of fear to one side of the lane or the other. On a single Lane road that means you might been too close to the double yellow or too close to the shoulder. If you need to prevent this there is a technique that you can used that is really helpful when you're learning, is to look farther ahead in the road and try to imagine the center of the road, picture a line in the center of the lane you're in passing through the center of your vehicle. This helps keep you in the center of your lane which is important for succeeding at the driver's test.
When coming to a stop sign or an stop or red light is important to stop before the white line in the road. That mean, when you're coming to a full stop, you should still be able to see the white line in front of the hood of your car ( This is important ). Then, if it's a blind turn, once you come to a full start, now you can start creeping out a little bit further and further so you can see the flow of traffic and make your right or left turn. Always use a safe following distance between yourself and the car is in front of you. The higher the speed limit is, the more the following distance because, if the person in front of you breaks all the sudden, you want to give yourself enough time to react.
Also, before you break, always check your rearview mirror. If you come onto a stop abruptly and there's a car right behind you, they could run into you. Obviously if it's an emergency situation this isn't always possible, but in the ideal case always check your mirror before braking.
Always keep your eyes constantly scanning the road for pedestrian, any obstacles or turns that are coming up. That means checking your mirrors constantly: Your rearview mirror, your side mirrors, looking over your shoulder. Being attentive and showing that you're paying attention is going to make a great impression to pass your road test.
When making protective left turns people often cut corners. Is something that everyone does on the road all the time: passing over a double yellow or a white line is a great way to fail your driver's test so make sure to take it wide enough, stay in the guidelines when you're making left turns and not cut any corners.
Be as smooth as possible. this means smooth steering inputs, smooth braking and smooth acceleration. Being jerky is not going to go well.
Drive defensively not aggressively. This day is about proving that you are a safe driver.
Don't speed. This is very important. In general people are used to going 5 miles an hour over the speed limit or so when driving in a daily situation but for the test you cannot do that. Speed limit or below is required.
Also having a radar detector in your car for the test if won't be a great idea.
The DMV wants to check if you are proficient with all the controls on the inside the car before you start the driver test.
Here's one sample of a pre-drive checklist:
In the USA there is a law called "Commercial Vehicles Security law", that establishes the requirements that a State must comply when issuing a commercial License. There are 3 different type of licenses:
Class A, for those vehicles that pass the 10.000 pounds of weight.
Class B, for those vehicles that has less than 10.000 òunds of weight.
Class C, for those vehicles that do not comply with the weights in class A or B but are designed to carry 16 passengers or more, or to carry dangerous goods materials.
The minimum age to apply for this license is 18 years old, except some exceptions in some States. Nevertheless, in case of interstate commerce it is essential that who applies counts with no less than 21 years of age. Previous to 1992, the year where this license was implemented, the requirements varied according to the State, as the commercial vehicles required special skills and knowledge.
The applicant wasn't always ready for this, and that led to a lot of accidents. From this year forward, after this law was released, the Federal HighWay administration (FHWA) developed some standard tests for those who wanted this special license, only those who successfully passed the written and the practice test could access the license.
The written test counts with a minimum of 30 questions about vial safety and parts of a trailer truck, to passmark is stated in 80 percent.
The driving test that every applicant must pass to access to the Commercial Drivers License may vary according to the State where it is issued. In general, the applicant must have practice hours that can be obtained through a program focused on teaching special abilities and maneuvers to trailer truck drivers.
This way, the operation of this vehicle becomes safer, and apart from this, the driver learns how to read maps and how to plan trips among other information. This type of vial education is a lot more completed and advanced than the one required for a regular drivers license. Actually, there are a large number of CDL Schools in the States, and also, a lot of truck companies own their own schools.
The driving test also requires the performance of some maneuvers that the driver must perform in the vehicle he or she wants to drive or a similar one with all the same equipment.
The drivers of commercial vehicles must prove that they are eligible at a physical level to drive these kind of vehicles, therefore, after the test is passed, he or she will have to be examined by a certified doctor from the Registry of Certified Medical Examiners, who will enable the driver before the Motorized Vehicles Office.
This website is privately owned and is not affiliated with any government agency. Remember that we are never going to solicit any personal information, ID or credentials. To find a list of official websites, please click here